Most “ruined siding” stories are the same story. Someone treated the wall like a driveway, aimed up under the laps, and found water in the wall or paint in the grass. Siding wants a soft wash: chemical, time, and a rinse that does not pry the courses apart.
What you are cleaning
Green and black growth on a north wall is alive. It will grow back if you only chip it off with pressure, and the pressure it takes to chip it off is enough to scar vinyl and drive water past the lap. A bleach cleaner applied with a pump sprayer, left for the time on the label, and rinsed gently is the usual method. Keep that cleaner out of the washer. The soap guide explains why, and names 30 Seconds as the bleach product to keep in its own sprayer.
Dirt without growth can come off with a house wash that the label allows and a wide fan. Test a low, hidden course first. Painted wood can peel from pressure alone, even when the chemical is mild. The Krud Kutter sheet says as much about painted surfaces. If the house was painted before 1978, assume lead is possible and do not dry-scrape or blast paint into the yard. That is a lead-safe work question, and it is bigger than a weekend rinse. Stop and look up the rules where you live.
Outlets, dryer vents, light fixtures, and the panel are not targets. Cover them. Skip the area under a service drop. Water and a damaged entrance cable are not a DIY experiment.
The rinse that does not open the wall
Use an electric washer or a gas washer turned down by tip choice and distance. You do not need 3,000 PSI on vinyl. The PSI guide is the range. A 40-degree tip is the default. A 25-degree tip is as narrow as most siding should see, and only while the wand is moving.
Spray downward, with the tip pointed slightly down so water runs off the lap instead of up behind it. Work from the bottom when you apply chemical, so you are not dragging cleaner through a dry, dirty section and leaving tiger stripes. Rinse from the top down, so dirty water leaves and does not dry on a section you already finished.
Keep the tip far enough away that the siding does not chatter. Chatter means the pressure is lifting the panel. Back up.
Windows can be rinsed. A focused jet at a seal or a screen will push water and tear mesh. Skip screens or take them down. Do not aim into a weep hole and hold the trigger.
Height, without a ladder
A ladder plus a pressure washer is how people fall. Recoil from the gun is real, and one hand will be on the trigger. Use a telescoping wand from the ground. The Simpson 80470 is the one listed here: 6 to 18 feet, a harness, cold water, and a 4,000 PSI ceiling. It is still too much wand for a 0-degree tip. Wide fan only.
Watch the balance. A long wand wants to climb. The harness is there so your back is not the only thing holding it. If you cannot keep the tip pointed down the wall, stop and do that section another way.
First-floor walls do not need the telescoping wand. The 16-inch Simpson 80149 or the wand that came with the washer is easier to control, as long as its PSI rating clears the machine. The nozzle and wand guide is the rating check.
After the wall dries
Look for lifted laps, drips at windows, and streaks you missed under eaves. A second chemical pass on a remaining green patch is better than moving closer with a narrow tip. Rinse plants again. Flush any soap tip you did use with clear water.
If water showed up inside a window or an outlet, stop washing and find where it entered before you wet that wall again. The goal is a clean exterior, not a damp wall cavity.